DEWATERING TECHNOLOGIES
MPCEE has been engaged by leading global manufacturers
of dewatering, drying and desalinisation technologies to spearhead their
respective further interests in a global market. The brief is to discuss with
specific industries our principal’s proven technology, where it can assist in
the economical reduction of sludge and slurries, where current technology is
unable to do so. We consider the issues of environmental protection and
pollution control are as important as reducing operating costs.
To allow for the multitude of different industrial uses
that differing technologies can be used for, it is important that you tell MPCEE
what you are looking for. Thereafter, it is possible to discuss in detail which
technology is best suited and the economics for building and operating it. This
is particularly relevant because of recent changes/amendments to environmental
legislation and regulation covering contaminated land, waste management and
IPPC. MPCEE will discuss with potential end users and others, the
viable economical possibilities for dealing with and disposing of sludge and
slurries from their operational environments.
It may well be that one type of technology may not be
suitable for the operational environment that it is intended for. However, in
order that MPCEE may present the right technology for these
needs, information is required to identify, for example, quantities of wet
tonnes per annum to pass through the technology, the percentage solids
required, along with operating costs for current disposal etc.
As the ramification of introducing new technology will
also affect all operations, where there is a need to substantially reduce the
capital and operating costs associated with the disposal of the sludge and
slurries, a pre-feasibility study will be necessary in this process of
identification, based on the answers to a series of questions. The link below
will take you to the questions page, which lists the required information:
|
This
information will allow an understanding of your present operating methods and
the costs involved, in order to undertake a pre-feasibility study to assist
you to compare and highlight future cost savings and profit |
The
following links will give you the basis of the technology used, which would be adapted
to the particular processes functioning at your plant:
|
TPS technology has a proven record of superior performance
in treating hydrocarbon-contaminated soils, sludge, sediments etc with a very
low water content. This is NOT a method of incineration |
|
|
The RAS Dryer is capable of drying a wide range of
materials from solids and pastes to slurries with moisture content in the
high 90’s down to below 1% moisture – in one single rapid pass |
|
|
PAD
is a high speed air jet, which facilitates the complete economic
drying of sludge and slurries etc for optimal commercial gain with a capital advantage of 5-1 and its energy cost advantage
of 15-1 |
|
|
The importance
of the recycling and treatment of organic wastes can be found in the
international requirement to have safe, secure and clean technology in the
methods used. Technology tested and proven and currently used in Space is now
available for Terrestrial use. Click for an important offer. |
For more
information on the operations of MPCEE click on: